- Grey/Light Grey flightsuit with either a mandarin-style collar (with pointed tab) or the same tab under another flipped up collar
- Correct arm pockets (shaped code cylinder pocket on upper left arm
- Rectangular pocket with a squared-flap closure on upper right arm)
- Thigh pockets with squared-flap closures (upper set required, lower set optional)
- No visible zippers or snaps
- Light Tan, Beige, or Taupe cloth or canvas spats over black boots
- Leather spats are not acceptable
- Spat height should be mid-calf to just under the knee and fall all the way down
- Spats should feature an additional strap (w/no buckle) of the same or similar material, running around the length around the calf approximately 1/8-1/4 down from the top of the spat
- Spats may feature single or double seam running down the front or back
- No laces should be visible
- Boots should be mid-calf black boots (Jack boots or engineer boots are acceptable)
- Leather pull-on style preferred with low heels
- No laces
- No ankle buckles (small buckle at top edge of boot allowable if covered by blousing)
- No non-black zippers
- Any zipper closure must either be hidden or on the inside calf
- No zippers on front or outside calf of boots
- High-Calf and Low-Calf boots are acceptable if fully covered by the spats
- White ejection harness and web belt, all 2” wide
- Belt may be off-white and is to buckle at the back with a black snap-release buckle
- Leg loops are individual per leg and split at the waist
- Belt is worn over the harness
- Accurately styled scoop-necked light grey/beige flak cloth or canvas vest with appropriate chest ribbing
- Shoulder ribbing and small black plastic snap-release buckles on the shoulder straps
- Side strapping should be white and 1.5″ – 2″ wide
- Shoulder strapping should match front and back panel material
- Back panel is smaller and differently shaped than the front but should match front panel material
- Small black/dark grey rectangular chest box on the upper chest
- Left side has wide, raised, lined section running vertically
- White oval belly box/tube with black strap and white cloth-covered hose attached at two points (either belly tube to flak vest, belly tube to flightsuit, or flak vest to flightsuit)
- Black gauntlet-style gloves (flared leather or pleather preferred, cloth or rubber gloves will not meet standards)
FORMAL REQUIREMENTS – YOU MUST HAVE AT LEAST ONE
- Y-Wing helmet with Star Wars-style decoration
- Mini-flares on web belt – a mix of filled and empty slots are okay
- Accurate Comm Pad (size, details, 3-dimensional, colouration, etc.) visible in the correct comm pad pocket on outside left forearm above wrist
- Metallic silver Code Cylinders (Arm Tools) in left shoulder pocket. Two minimum; four maximum. Cylinder heads showing should resemble screen accurate representations