Episode VI : Y-WING PILOTE

Modérateur : Modérateur Squadron

jedichrist
Membre RLFB
Membre RLFB
Messages : 5730
kuchnia na wymiar wrocław
Inscription : dim. 03 févr. 2008, 18:26
Localisation : BERGERAC

Episode VI : Y-WING PILOTE

Message par jedichrist »

REQUIRED ITEMS
  1. Grey/Light Grey flightsuit with either a mandarin-style collar (with pointed tab) or the same tab under another flipped up collar
    • Correct arm pockets (shaped code cylinder pocket on upper left arm
    • Rectangular pocket with a squared-flap closure on upper right arm)
    • Thigh pockets with squared-flap closures (upper set required, lower set optional)
    • No visible zippers or snaps
  2. Light Tan, Beige, or Taupe cloth or canvas spats over black boots
    • Leather spats are not acceptable
    • Spat height should be mid-calf to just under the knee and fall all the way down
    • Spats should feature an additional strap (w/no buckle) of the same or similar material, running around the length around the calf approximately 1/8-1/4 down from the top of the spat
    • Spats may feature single or double seam running down the front or back
    • No laces should be visible
  3. Boots should be mid-calf black boots (Jack boots or engineer boots are acceptable)
    • Leather pull-on style preferred with low heels
    • No laces
    • No ankle buckles (small buckle at top edge of boot allowable if covered by blousing)
    • No non-black zippers
    • Any zipper closure must either be hidden or on the inside calf
    • No zippers on front or outside calf of boots
    • High-Calf and Low-Calf boots are acceptable if fully covered by the spats
  4. White ejection harness and web belt, all 2” wide
    • Belt may be off-white and is to buckle at the back with a black snap-release buckle
    • Leg loops are individual per leg and split at the waist
    • Belt is worn over the harness
  5. Accurately styled scoop-necked light grey/beige flak cloth or canvas vest with appropriate chest ribbing
    • Shoulder ribbing and small black plastic snap-release buckles on the shoulder straps
    • Side strapping should be white and 1.5″ – 2″ wide
    • Shoulder strapping should match front and back panel material
    • Back panel is smaller and differently shaped than the front but should match front panel material
  6. Small black/dark grey rectangular chest box on the upper chest
    • Left side has wide, raised, lined section running vertically
  7. White oval belly box/tube with black strap and white cloth-covered hose attached at two points (either belly tube to flak vest, belly tube to flightsuit, or flak vest to flightsuit)
  8. Black gauntlet-style gloves (flared leather or pleather preferred, cloth or rubber gloves will not meet standards)

FORMAL REQUIREMENTS – YOU MUST HAVE AT LEAST ONE
  • Y-Wing helmet with Star Wars-style decoration
  • Mini-flares on web belt – a mix of filled and empty slots are okay
  • Accurate Comm Pad (size, details, 3-dimensional, colouration, etc.) visible in the correct comm pad pocket on outside left forearm above wrist
OPTIONAL REQUIREMENT
  • Metallic silver Code Cylinders (Arm Tools) in left shoulder pocket. Two minimum; four maximum. Cylinder heads showing should resemble screen accurate representations
Dernière modification par jedichrist le sam. 12 août 2017, 17:32, modifié 1 fois.

Verrouillé

Revenir à « PILOTES TRILOGIE CLASSIQUE »